VPS Panel

Install VPS Panel.

Deploy Go functions and manage PostgreSQL on your own VPS. Run the installer over SSH, then finish setup in your browser.

Read the setup steps
VPS terminal

The public installer is pending publication.

Before you start

Use a fresh VPS with systemd and an SSH account with sudo access.

Operating system
Ubuntu 24.04 or Debian 12
CPU architecture
amd64 or arm64
Minimum resources
2 GB RAM · 20 GB free disk
Public HTTPS
Optional hostname · TCP 80 and 443

Set up your panel

Keep your SSH session open until the browser setup is complete.

  1. Run the installer on your VPS

    Connect with SSH and run the command shown above when a release is available. The installer verifies the release archive and prints a one-time setup link.

  2. Open the setup link through SSH

    In a second terminal on your computer, run the SSH forwarding command printed by the installer. Keep that terminal open and visit the printed localhost link in your browser. Set an owner password of at least 12 characters.

  3. Connect a domain when you’re ready

    In Settings → Server, add a hostname whose DNS points to your VPS. Sign in at the new HTTPS address to close the temporary setup listener.

How do I update an existing installation?

Run the same install command again. The installer checks the new release and restores the previous one if the health check fails.

What if I lose the setup link?

Run the install command again before claiming the panel. It issues a new link and invalidates the old one.